Installation of the mixed Paperstone and maple butcher-block counters only took a couple days, but during the preceding several months, the old faucet had progressively declined until it only provided a mere trickle. The original counters were tile that still looked and functioned great, despite decades of wear; but the original cast iron undermount sink had been the victim of an unfortunate resurfacing job, and its time had finally come. Because of the age of the tile, it would have been near impossible to replace the sink and patch the tile so that it would look like a plausible match. (A few years previous I added a new section of matching cabinets to the kitchen, and because it was located on an opposite wall we were able to get away with using an imperfect match for the backsplash tile; but it would be nowhere near close enough for a side-by-side patch). In addition to all of that, the space behind the sink was too narrow to allow a faucet to fully function; so the old tile counters had to go.
We chose Paperstone for the sink section because of its resistance to water, durability, and sustainability; and maple butcher block for the "wing" sections because it matched existing butcher block in another section of the kitchen, and it balanced the muted, black texture of the Paperstone. The asymetric shape of the stainless steel undermount sink allowed for the faucet to be placed slightly further forward so that it fully functioned and had plenty of space to operate. Aside from fabricating a couple small tile patches from pieces of the old counter, the tile backsplash was left alone and works quite well with the considerably more modern counters and plumbing fixtures.